1. Mount the large breadboard board.
2. Two FND indicators capable of expressing hexadecimal numbers are installed. 3. The Common Mode of the indicator can be switched. 4. A DC power supply of 5V, 3A is sufficient. 5. 1㎐, 100㎐, 1㎑, 100㎑ waveforms can be selectively output by the square wave generator. 6. In case of overcurrent output, the piezo operates to warn that it is in an overload state.
1) DC power supply: 5V,3A overload protection circuit and alarm output (piezo) Over Load LED on
2) 4-bit logic monitor LED (H: on, L: off) × 2EA
3) BCD DISPLAY: 2-Digit (Hexadecimal number indicator)
0 1 2 3 4 5 6 7 8 9 ABCDEF
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 4) Common Mode Conversion Switch : Anode / Cathode 5) Logic Supply Switch : 4-Toggle SW × 2EA 6) Logic supply indicator: 4-LED indicator × 2EA 7) Square wave output: Output selected by 1㎐, 100㎐, 1kHz, 100㎑ selection switch 8) SINGLE pulse output 9) RUN switch: Square wave output Control 10 ) Bread board : Socket Tie-Point — 3150point Bus Tie-Point — 700point 11) Input Power: AC 220[V],50/60[㎐] 12) Dimension: 130(H) × 390(W) × 270(D)㎜ 13) Accessories